Open the Properties Dialog by right-clicking the corresponding entry on the Media Pool category Devices and selecting the corresponding device port below it. In the right Media Pool section right-click the corresponding entry and select Properties.
For Name you can enter a corresponding name.
For Address enter the required address. It needs to correspond to the SC Net hardware address. See also Configuring the SC Net system.
DMX mode, by default, is set to 8 Bits. However, it is also possible to output 16 bits if you use two DMX channels for one data object. One of these channels is set to 16 Bits MSB and the other one to 16 Bits LSB. This function is only possible for devices that are able to read two such channels.
When there is a checkmark next to Create start status, the device status is output during playback when starting the timeline, i.e. even before the data objects or value markers are played back. This behavior may result in undesired and hard dissolves, e.g. due to triggers and jump markers, when jumping to other timelines. In such a case you should not have a start status produced.
The start status does not have an effect for playback of CF Card shows via the SC Master but only for playback via Wings Vioso RX.
See also