Thementext hier eingeben
When a project is loaded via Autostart following Windows start-up and activation of the device ports fails or no connection to control units can be established, this may be due to the USB ports of your computer. In a number of hardware/software configurations, connected USB devices may block the serial computer ports during first-time access.
Solutions:
Place a trigger at the beginning of the show which enables the device ports again. Use trigger category Wings Vioso RX and Action Enable device ports. Following this, drag the trigger into the timeline. As an alternative, you can also execute the trigger via the scheduler (...both functions require the Show Control Module). See also Trigger functions.
Or do without USB devices and use a parallel port dongle..